Úvod » IBIS CYCLES » IBIS ZAPL.KOLA • RÁFKY » IBIS RIM ALU SEND I 27.5"


        

IBIS RIM ALU SEND I 27.5"

přední asymetrický hliníkový ráfek 27.5"

 

Číslo produktu: RIM SEND I AL 27.5
Výrobce: IBIS CYCLES
Vaše cena bez DPH : 2 479 CZK
Vaše cena s DPH (21 %):
2 999 CZK

do košíku:
  kus  

Introducing the Send rims and wheels from Blackbird, a new component brand for Ibis Cycles. When we set out to improve our industry-leading Ibis aluminum S35 rims our mission was simple; eliminate pinch flats and keep the tire sealed no matter what you hit.

Pinch flats occur when you hit your wheel hard enough to “pinch” the tire between your rim and that rock or root that you didn’t see coming. Hit hard enough and the edge of your rim, the bead wall, will slice clean through that brand-new tire you just installed.

To eliminate pinch flats, we designed our bead walls with a hollow box-section profile to remove the sharp edges and create a broad contact point with the tire. This box-section results in a stronger bead wall that doesn’t slice tire sidewalls and it doesn’t add any additional weight.

Our unique bead wall is used on both the Send 1 and Send 2 rims, but our Send 2 gets a little something extra.

If you ride hard, you know you’re going to dent your aluminum rims eventually and it’s your rear wheel that takes the brunt of the damage. You can bend back a bead wall but dent your bead seat (where your tire seals) and you’ll be walking back to the trailhead. You can’t bend the bead seat back, which means you can’t run your tires tubeless - at that point they’re worthless because tubes are dead to us.

To reinforce the bead seat on our Send 2 rims, we added a pair of ribs directly beneath our bead seat. The Send 2 gains 45g per rim because of this reinforcement but it is a small penalty compared to the weight of the insert you need to protect flimsier rims.

  • 6061 Aluminum
  • Intended use: Mountain Bikes
  • Internal Rim Width: 35mm
  • Outer Rim Width: 44mm
  • Section Height: 17mm
  • ERD: 604mm & 5mm offset
  • 32 hole drilling, optimized for 3 cross lacing
  • Send I Rim weight: 565g
  • Send II Rim weight: 625g
  • Recommended Tire Width: 2.35-2.8"
  • Max PSI: 40  (2.75 BAR)
  • Valve Type: Presta
  • 7 year warranty
  • Single graphic line over valve hole signifies Send 1 rim
  • Double graphic line over valve hole signifies Send 2 rim

--

Veškeré publikované fotografie na těchto stránkách mají pouze ilustrační charakter, nemusí zobrazovat skutečný kit.
Cena a specifikace se mohou změnit bez předešlého upozornění.
Dovoz a distribuci produktů IBIS CYCLES zajišťuje výhradně společnost 93 95, s.r.o.

NÁZORY A DOTAZY NÁVŠTĚVNÍKŮ

Nebyl zatím přidán žádný názor. Přidejte svůj názor nebo dotaz jako první.

Vytvořeno systémem www.web-rychle.eu

N2RmOTExYj